Organix Concept Ltd. BA165 Manual Do Utilizador
FCC Statement:
Note：
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules.
This device is a mobile device, should be 20cm away from human body, when it is in working mode.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two condi-
tions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
INSTRUCTION MANUAL FOR LED PANEL AND REMOTE CONTROL
There are 4 buttons on the remote control : A, B, C and D
And1 button at the back of the signal panel : E.
Working frequency : 2.4GHz
Step one
Press the button (E) at the back of the signal panel to switch it on : you would see a green light turn on.
Step two
Press the buttons on the remote control to indicate your direction. They will light up to insure you that you
have well pressed the button.
Battery use and life span :
The panel is sold with the USB cable. The panel fully charged will operate on a continuous mode between 6
The remote control operates with 2 CR2025 batteries. The autonomy of the remote control batteries is about
50 hours in active mode. In order to save battery, make sure to stop the remote control by a 2 second long
press on button A.
Please remove the battery insulator tab before use.
E
A
B
C
D
How to place the LED panel in the backpack properly ?
Turn the LED panel ON, then place it into the backpack’s LED pocket.
Turn the LED panel ON, then place it into the backpack’s LED pocket.
Pay special attention to place the LED panel in the correct direction in the backpack.
Pay special attention to place the remote control in correct side on your handlebars.
Wrap the silicon strap of remote control around the handlebars of your bicycle.
top
bottom
Press the upper arrow ( A ), to show you are going straight forward on the LED panel.
You will see this signal on the LED panel.
Press the left arrow ( B ), to show you are turning left on the LED panel.
You will see this signal on the LED Panel :
Left arrow will blink for 1minute. To go back to upper arrow before 1 minute, press A.
Press the right arrow ( C ), to show you are turning right on the LED panel.
You would see below this signal the LED Panel :
Right arrow will blink for 1 minute. To go back to upper arrow before 1 minute, press A.
Press the warning sign (D), when you would like to show a danger or a stop
von the LED panel. You will see this signal on the LED panel.
Warning sign will blink until you press another button.
A brake motion sensor is integrated in the LED panel. In case of a strong brake,
the red danger sign will turn on to warn people that you have stopped abruptly.
You will see this blinking signal on the LED panel.
Danger sign will disappear as soon as you start moving again.