Atoms Labs LLC AWSC37 Manual Do Utilizador
QUICK START GUIDE
PRODUCT OVERVIEW
INSTALLING YOUR DEVICES
A. Setting up your monitor
1. Insert the memory card and/or connect HDD device to USB port.
2. Twist on the antenna to the LEFT side of the console.
3. Connect the Ethernet cable from the BACK of the console to your router.
4. Connect the 12V power adaptor and power on the system.
5. Twist on the stand to the back of the console.
1. Insert the memory card and/or connect HDD device to USB port.
2. Twist on the antenna to the LEFT side of the console.
3. Connect the Ethernet cable from the BACK of the console to your router.
4. Connect the 12V power adaptor and power on the system.
5. Twist on the stand to the back of the console.
Antenna
Power Botton
Internet
Router
Mobile Device
Connect system directly after the router. Do not
connect system to router through a hub or switcher.
Enable DHCP and UPnP on your router. TCP port
#6000 and #80 should be opened.
connect system to router through a hub or switcher.
Enable DHCP and UPnP on your router. TCP port
#6000 and #80 should be opened.
Reset Botton
USB Port
Memory Card Slot
Power Jack
Note: Before using the memory card/ HDD
for recording video, you MUST format the
memory card/ HDD on the console.
for recording video, you MUST format the
memory card/ HDD on the console.
KIT CONTENT
*
Camera / Receiver Antenna
*Camera Stand
*Digital Wireless Outdoor
IR Camera
Ethernet Cable
x 1
Screw Pack (For Camera )
Camera / Receiver Adaptor
Camera power
adapter-5V/1.5A
adapter-5V/1.5A
x 1
HDNVR power
adapter-12V/2A
Digital Wireless Receiver
Console
x 1
Note: Keep distance between device minimum 1 meter.
Monitor
Router
1 M+
1 M+
1 M+
1 M+
1 M+
*Quantity varied subject to configuration
Thumb Screw
B. Installing your camera
1. Secure the camera stand to a stable surface, celling or wall mount using three pcs screws.
2. Loosen the thumb screw of the camera stand and secure the camera body to the bracket.
3. Screw the antenna into rear of the camera.
4. Connect the supplied power adaptor to the camera and the power source. The RED LED
will light up which indicate the camera is ready for setup.
1. Secure the camera stand to a stable surface, celling or wall mount using three pcs screws.
2. Loosen the thumb screw of the camera stand and secure the camera body to the bracket.
3. Screw the antenna into rear of the camera.
4. Connect the supplied power adaptor to the camera and the power source. The RED LED
will light up which indicate the camera is ready for setup.
(1)
(2)
(3)
HD Monitoring System Accessory Camera
AWSC37
AWSC37