HULU ROBOTICS TECHNOLOGY COMPANY LIMITED 1300133B Manual Do Utilizador

 

VCC 

 

 

5V power input terminal   

 

GND 

 

 

5V power ground wire   

 

TX 

OUTPUT 

5V 

Serial port communication output 

terminal 

 

RX 

INPUT 

5V 

Serial port communication input terminal 

 

DTR 

OUTPUT 

5V 

Data terminal ready 

 

RST 

INPUT 

5V 

Module resetting pin; low electric level 

being effective 

 

 

The function of Bluetooth (Dual Mode) is to transfer Bluetooth communication to serial port 

communication, namely to transfer the received Bluetooth data to serial port data output and send out the 

received serial port data in Bluetooth mode. It is duplex communication and it is compatible with Bluetooth 

2.1+EDR and 4.0 protocols. When using Bluetooth 2.1+EDR protocol communication, the highest speed 

within 10 meters can be up to 8K bps, while the communication speed of 4.0 protocol can be up to about 

1K bps.   

 

(1) Install our APP control software in your mobile equipment (like cell phone); 

(2) Insert Bluetooth module into the socket interface of wireless module of mCore main control panel. 

After the power is on, the indicating lamp in the module is in off state for the first three to four seconds and 

then becomes in twinkling state. The twinkling indicating lamp means that Bluetooth module has not been 

connected with your equipment. After your equipment is connected with the module, the indicating lamp 

will keep in on state.   

(3) When the module indicating lamp twinkles, turn on the Bluetooth of your equipment and search 

Bluetooth device, and select the Bluetooth device named “Makeblock” to make the connection among the 

found device.   

(4) After successful connecting, open APP software installed in the first step and then you can start to 

control the main control panel of mCore.   

Dimension: 30mm*20mm*14mm (Length x Width x Height) 

Software Version: V1.1 

Hardware Version: V1.1