Ulterius Technologies LLC FDN40 Manual Do Utilizador
CHAPTER 2: SYSTEM FEATURES
Configuration User Manual
40
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
2.2.10 Configuring the Default VLAN Identifier
Configuring the default VLAN identifier results in the VLAN ID to be written to
the NVRAM and this will be used as the default VLAN ID when the switch is
restarted.
the NVRAM and this will be used as the default VLAN ID when the switch is
restarted.
2.2.10.1 CLI Configuration
1. Execute the following commands to configure the default VLAN identifier.
Enter the Global Configuration mode.
UltOs# configure terminal
Configure the default VLAN ID as 10.
UltOs(config)# default vlan id 10
Exit from the Global Configuration mode.
UltOs(config)# end
2. View the default VLAN ID by executing the following command.
UltOs# show nvram
Default IP Address : 10.0.0.100
Default Subnet Mask : 255.255.0.0
Default IP Address Config Mode : Manual
Default IP Address Allocation Protocol : DHCP
Switch Base MAC Address :
00:01:02:03:04:01
00:01:02:03:04:01
Default Interface Name : wan0/1
Default RM Interface Name : eth0
Config Restore Option : No restore
Config Save Option : No save
Auto Save : Enable
Incremental Save : Disable
Roll Back : Enable
Config Save IP Address : 0.0.0.0
Config Save Filename : FDN40.conf
Config Restore Filename : FDN40.conf
PIM Mode : Sparse Mode
IGS Forwarding Mode : MAC based
Cli Serial Console : Yes
SNMP EngineID :
80.00.08.1c.04.46.53
80.00.08.1c.04.46.53
SNMP Engine Boots : 0
Default VLAN Identifier : 10
Notes: