ZIF LATINOAMERICA S.A. Z35 Manual Do Utilizador

Warning:

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help.

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.

Device types Z35 (FCC ID: 2AE58-Z35) has also been tested against this SAR limit. The

highest reported SAR values for head, body-worn

accessory, and product specific (Hotspot) are 0.76 W/kg, 0.86 W/kg, and 0.86 W/kg resp

ectively. This device was tested for typical body-worn operations with the back of the

handset kept 10mm from the body. To maintain compliance with FCC RF exposure

requirements, use accessories that maintain a 10mm separation distance between the

user's body and the back of the handset. The use of belt clips, holsters and similar

accessories should not contain metallic components in its assembly. The use of

accessories that do not satisfy these requirements may not comply with FCC RF exposure

requirements, and should be avoided.