NEOSEN ENERGY EZI Manual Do Utilizador
B.2. Firmware Updates
When there is a firmware update, Neosen Energy will make the update available
for download. The transmitter is updated by connecting the device to a
computer using a USB 2.0 Micro Type-B to USB Standard Type-A cable.
for download. The transmitter is updated by connecting the device to a
computer using a USB 2.0 Micro Type-B to USB Standard Type-A cable.
C. SHEET PREPARATION
C.1. Optional Inlay/Laser Engraving
Charging location marking methods that require fabrication should be
performed before milling the pocket for the transmitter. Standard techniques for
engraving or creating inlays may be used to identify the charging location. If
the customer does not desire a permanent indicator a temporary sticker may be
used and may be applied when fabrication is complete.
performed before milling the pocket for the transmitter. Standard techniques for
engraving or creating inlays may be used to identify the charging location. If
the customer does not desire a permanent indicator a temporary sticker may be
used and may be applied when fabrication is complete.
C.2. Milling Pocket
The wireless power transmitter is optimized for a surface thickness of 8 mm
(0.315"). A CNC is highly recommended for pocket milling as the distance is
registered from the face of the sheet, whereas a hand router distance is
registered off the back of the sheet, which may induce more variability in
remaining sheet thickness.
(0.315"). A CNC is highly recommended for pocket milling as the distance is
registered from the face of the sheet, whereas a hand router distance is
registered off the back of the sheet, which may induce more variability in
remaining sheet thickness.
The pocket should be milled as a circle of 63.5 mm (2.5") with remaining
material thickness of 8 mm (0.315"). Use a flat-tipped end mill bit with a 3 mm
(0.118") radius on the tip for a uniform surface in the cavity.
material thickness of 8 mm (0.315"). Use a flat-tipped end mill bit with a 3 mm
(0.118") radius on the tip for a uniform surface in the cavity.
Make sure that once the transmitter is installed there will be clearance for
attaching the power plug and that there is access to the micro USB port for
potential firmware updates.
attaching the power plug and that there is access to the micro USB port for
potential firmware updates.
D. TRANSMITTER INSTALLATION
D.1. Adhering transmitter to sheet
Remove all dust and shavings. Clean the sheet
and flange of the transmitter with a clean cloth
dampened with denatured alcohol
and flange of the transmitter with a clean cloth
dampened with denatured alcohol
1
. Verify the
desired orientation of the transmitter so that the
power and USB ports will be accessible after
installation. The flange will sit slightly above
the surface when the coil is in contact with the
cavity surface.
power and USB ports will be accessible after
installation. The flange will sit slightly above
the surface when the coil is in contact with the
cavity surface.