Advanced Warning Systems LLC AWS-RC Manual Do Utilizador

INSYTE PRODUCT OPERATION DESCRIPTIONS

Page 8 of 8

shown in the device list on the remote control OLED screen.

Step 3: To Add Camera

Use the COUPLE Command of the Remote Control device in the MAIN MENU to perform coupling between

Stealth Camera device and Remote Control device. (This is similar to the above step; you just need to press the

“COUPLE” button on the Camera. Then RC device will be coupled with this Camera.)

Step 4:

To Arm InSyte Device

There are two ways to arm the InSyte device. One way is to use ARM command of the Remote Control device

in the MAIN MENU to arm all InSyte devices that linked to this remote control. To do so, please move the

cursor to the ARM command and press “ ” button. The other way is to press the “

” key sequence on the

InSyte device (single device only). Then, the InSyte RED light on the InSyte device will flash. During this

time, please place the InSyte device on a stable surface such as on a table or in a drawer. This light will go off

after for two seconds, it indicates that the InSyte device is armed.

Step 5:

To Test the motion

Now, please try to move the InSyte device and wait for the alarm to go off. Once the InSyte alarm goes off, a

loud transducer sound with more than 85dB will sound continuously until user stop it. (Please see the next

step.) At the same time, if the remote control is linked with a stealth camera, then the stealth camera will start

to take still pictures as well as to record video images for 2 minutes.

Step 6:

To Disarm InSyte device

There are two ways to disarm the InSyte device. One way is to use DISARM command to disarm all InSyte

devices that linked to this remote control. To do so, please move the cursor to the DISARM command and

press “ ” button. The other war is to use the keypad on the InSyte device to disarm that InSyte device (single

device only). To do so, press the key sequence of “ #### ”, where “####” is the password digits. If the

correct password is entered, then this InSyte device will be disarmed immediately, and a reminder message

will be played.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment.