Envisacor Technologies ENVV00012 Manual Do Utilizador

 

 

 

 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance with the instruction, may 
cause harmful interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try and correct the interferene by one of the following measures: 
 
Reorient or relocate the receiving antenna, 
Increase the separation between the equipment and receiver, 
Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undersired operation. 
 
FCC Caution: Any changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate this equipment. 
 

 

Vision Guarantees that every transmitter is free from physical defects in material and 
workmanship under normal usage for one year from the date of purchase. If the product 
proves defective during this one-year warranty period, Vision will replace it free of charge. 
Vision does not issue any refunds. This warranty is extended to the original end user 
purchase only and is not transferable. This warranty does not apply to : (1) damage to 
units caused by accident, dropping or abuse in handling, or any negligent usage; (2) 
units which have been repaired, taken apart, or modified by an authorized personnel; (3) 
units not used in accordance with instruction; (4) damages exceeding the cost of the 
product; (5) transit damage, initial installation costs, removal cost, or reinstallation cost. 

-3-