Camden Door Control TX99 Manual Do Utilizador

Installation Instructions

Camden CM-TX-99 RF Transmitter is ideal for applications 

where running additional cable is expensive or impractical.   

CM-TX-99 is installed by aligning the pins with the socket on 

the CM-120i/W Keypad or  

CM-325 Touchless switch and plugging it in. 

CM-TX-99 is easily paired with Camden CM-RX-91 and CM-

RX-92 Lazerpoint™ Receivers. 

To learn the transmitter into the receiver, press the PB1 button 

(on the CM-RX-91/92) using a small blunt object, such as a 

small blade screwdriver or similar.  Within 10 seconds, enter 

a valid user code on the CM-120i/W Keypad connected to a 

CM-TX-99 transmitter. The Green LED Array will flash once to 

confirm enrollment.

To learn the transmitter into the receiver, press the PB1 button 

(on the CM-RX-91/92) using a small blunt object, such as a 

small blade screwdriver or similar.  Within 10 seconds, wave 

your hand in front of the CM-325 connected to a CM-TX-99 

transmitter to activate the switch. The Green LED Array will 

flash once to confirm enrolment.
If you wait longer than the 10-second period, the receiver will 

time out of Learn Mode and revert back to standby. The LED 

will then flash to indicate  

the number of transmitters learned into the receiver.

1

CM-TX-99 Lazerpoint™ 

RF Transmitter

CAMDEN DOOR CONTROLS CM-TX-99 RF Transmitter is designed for industrial and 

commercial applications, where wireless operation is required. The transmitter is 

a plug-in board designed to interface to the CM-120i/W Keypads and the CM-325 

Touchless Switch. 

(40mm)

19⁄16”

(15mm)

9/16”

(6mm)

1/4”

(8mm)

5/16”

CAMDEN

LAZERPOINT

Page 1 of 2