Extron electronic DTP HDMI 330 Manual Do Utilizador

This guide provides quick start instructions for an experienced installer to set up and operate the 
Extron DTP HDMI 330 digital video extender. The DTP HDMI 330 transmitter and receiver pair can 
extend an HDCP-compliant HDMI signal up to 330 feet (100 m).

Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.

a

  HDMI Input connector (Tx) — Connect an HDMI 

cable

  

between this port and the HDMI output port of 

the digital video

 

source.

 

See “

“on the back of this guide for to securely 

fasten the input HDMI connector to the transmitter.

b

  Audio input (Tx) — Connect an unbalanced stereo audio source to this 3.5 mm mini 

stereo jack for an analog audio input.

c

  RS-232 and IR connectors — To pass serial or infrared data or control signals, such as 

serial control of a projector, connect the master device to the transmitter and the slave 
device to the receiver via the RS-232 and IR captive screw connectors on both units.

d

  DTP RJ-45 connectors — Connect transmitter DTP Out to receiver DTP In. 

Extron recommends that you terminate both cable ends in accordance with the 
following specifications, at a minimum:

 

z

TIA/EIA T 568 B 

z

CAT 6A, shielded

 

z

24 AWG, solid conductor

ATTENTION:  Do not connect these devices to a computer data 

or telecommunications network.

Signal LED — Lights when the unit is receiving a clock signal on the HDMI input (for the transmitter) 
or any valid signal on the DTP In connector (for the receiver).
Link LED — Lights when a valid link is established between the units on the DTP cable.

e

  HDMI Output connector (Rx) — Connect a display with an HDMI input for display of the 

transmitted direct digital image.

 

to securely fasten the output HDMI connector to the receiver.

f

  Audio Output connector (Rx) — Connect a balanced or unbalanced stereo or mono audio 

device to the receiver via the Audio captive screw connector. See the drawing below.

Tip

Ring

Tip

Ring

Sleeves

Tip

No Ground Here

No Ground Here

Tip

Sleeves

  Connect the sleeves to the ground contact. DO NOT connect the sleeves to the negative (-) contacts.

White-green

Green

White-orange

White-blue

Orange

White-brown

Brown

Blue

TP Wires

12345678

5

1

2

3

6

7

8

4

Ground

Receive pin on connected unit

Transmit pin on connected unit

Receive pin on connected unit

Transmit pin on connected unit