Panasonic PT-LX26E Manual Do Utilizador

J

The lamp unit is a consumable component. You can check the total usage time using Lamp runtime in the 

[Information] menu on page 53.

It is recommended to ask an authorized engineer to replace the lamp unit. Contact your dealer.

Consult your dealer to purchase a replacement lamp unit (ET-LAL100).

The inside of the cover can become very hot, take care to avoid burn injuries.

J

The luminous source of the lamp is made of glass and may 

 

z

burst if you hit it against a hard surface or drop it. 

Please handle with care.

A Phillips screwdriver is required for replacement of the lamp 

 

z

unit.

When replacing the lamp unit, be sure to hold it by the handle.

 

z

When replacing the lamp because it has stopped illuminating, 

 

z

there is a possibility that the lamp may be broken.

If replacing the lamp of a projector which has been installed 

 

z

on the ceiling, you should always assume that the lamp is 

broken, and you should stand to the side of the lamp cover, 

not underneath it. Remove the lamp cover gently. Small pieces 

of glass may fall out when the lamp cover is opened. If pieces 

of glass get into your eyes or mouth, seek medical advice 

immediately.

The lamp contains mercury. Consult your local municipality or 

 

z

your dealer about correct disposal of used lamp units.

Do not use other than designated lamp units.

 

z

The part numbers of accessories and separately sold components are subject to change without notice.

 

z

J

The lamp unit is a consumable component. Brightness decreases according to duration of usage, so 

periodical replacement of the lamp unit is necessary. 

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the 

screen and <LAMP> indicator lights yellow. Replace the lamp with a new one promptly.

Lamp runtime

  On screen

    Lamp replacement icon

LAMP indicator

   Over 3000 hours*

   Over 3200 hours*

The message is displayed for 10 seconds. If you 

press any button within the 10 seconds, the message 

disappears.

If the power is turned on without replacing the lamp, 

the power automatically turns off after approximately 

ten minutes to prevent the malfunction of the projector.

Lights in yellow (even in  

stand-by mode).

* 3200 hours of use is a rough guideline, but is not a guarantee. The lamp runtime differs depending on the   

   setting of "Lamp power" menu.

The Lamp replacement icon will not appear when the [Display] function is set to [Off] (

 

z

Æ

page 47), or during 

[Freeze] (

Æ

page 30), or [Blank] (

Æ

page 30).