Epson 9600 Manual Do Utilizador

When you’re not using the Auto Cut setting, you need to cut the paper 
manually after your print job is finished. If you’re printing on canvas, vinyl, 
or other heavy media, you should use scissors or the optional media cutter 
rather than the built-in cutter. Heavy media can damage the built-in cutter.

Do not use the built-in cutter to cut any of the following materials:

Follow these steps to cut manually with the built-in cutter:

1. If the paper is not positioned correctly, press one of the 

Paper

 

Feed

 

buttons to adjust the paper position. Normally, you don’t need to do 
this after a print job is finished.

2. Press the 

Paper

 

Source

 button until the 

Roll

 

Auto

 

Cut

 light comes on.

3. Press the 

Cut/Eject

 button. The paper is cut.

You can print trim lines on the right edge of your pages (if you’re using Auto 
Cut) or on the right and bottom edge (if you’re not using Auto Cut). 

1. Press the 

SelecType

 button. 

PRINTER SETUP

 appears on the display.

2. Press the 

r

 button until 

PLATEN GAP

 appears.

3. Press the

 d

 button until 

PAGE LINE 

appears.

4. Press the 

r

 button. 

*OFF

 is displayed as the current setting.

An optional media cutter 
is available for cutting 
thick media. See page 10 
for details on ordering it.

•

Smooth Fine Art paper

•

Backlight Film

•

Textured Fine Art paper

•

Heavyweight Polyester Banner

•

Canvas

•

Adhesive Vinyl

•

Enhanced Matte Posterboard

•

any similar third-party papers or 
papers thicker than 10 mil

•

Somerset Velvet Fine Art paper

You can also specify trim 
lines from your printer 
driver software. See 
page 91 (Macintosh) or 
page 115 (Windows) for 
more information.