Adaptec SCSI Card 2930 Ultra AHA2930U-ROHS-KIT Manual Do Utilizador
Códigos do produto
AHA2930U-ROHS-KIT
B-7
Configuring the SCSI Card 2930CU with SCSISelect
■
BIOS Support for Int 13 Extensions
—When set to Enabled, the
SCSI card BIOS supports Int 13h extensions as required by Plug-
and-Play. The setting can be either enabled or disabled if your
system is not Plug-and-Play.
and-Play. The setting can be either enabled or disabled if your
system is not Plug-and-Play.
Using SCSI Disk Utilities
To access the SCSI disk utilities
1
From the main SCSISelect menu, select SCSI Disk Utilities.
SCSISelect scans the SCSI bus and displays a list of all SCSI IDs
and the devices.
and the devices.
2
Use the
↑ and ↓ keys to move the cursor to a specific ID and
device, then press Enter.
3
A small menu appears, displaying two options:
■
Format Disk
—Allows you to perform a low-level format on
a hard disk drive. (Most SCSI disks are preformatted at the
factory and do not need to be formatted again.) Each hard
disk drive must be low-level formatted before you can use
your operating system’s partitioning and file preparation
utilities, such as MS-DOS
factory and do not need to be formatted again.) Each hard
disk drive must be low-level formatted before you can use
your operating system’s partitioning and file preparation
utilities, such as MS-DOS
Fdisk
and
Format
.
Caution:
A low-level format destroys all data on the
hard disk drive. Be sure to back up your data before
performing this operation. You cannot stop a low-level
format once it is started; therefore, do not turn the
power off to stop this operation.
performing this operation. You cannot stop a low-level
format once it is started; therefore, do not turn the
power off to stop this operation.
■
Verify Disk Media
—Allows you to scan the media of a hard
disk drive for defects. If the utility finds bad blocks on the
media, it prompts you to reassign them; if you select Yes,
those blocks are no longer used. You can press Esc at any
time to stop the utility.
media, it prompts you to reassign them; if you select Yes,
those blocks are no longer used. You can press Esc at any
time to stop the utility.
!