ZyXEL ADSL Prestige 662HW-61 130122.0662HW61 Manual Do Utilizador

Prestige 662H/HW Series User’s Guide

335

Chapter 31 Remote Node Configuration

Figure 173   Menu 11.1 Remote Node Profile

Move the cursor to the Edit Advance Options field, press [SPACE BAR] to select Yes, then 
press [ENTER] to display Menu 11.8 – Advance Setup Options.

Figure 174   Menu 11.8 Advance Setup Options

The following table describes the fields in this menu.

      Menu 11.1 - Remote Node Profile

  Rem Node Name= MyISP                 Route= IP
  Active= Yes                          Bridge= No
  Encapsulation= PPPoE              Edit IP/Bridge= No
  Multiplexing= LLC-based              Edit ATM Options= No
  Service Name=                        Edit Advance Options= Yes
  Incoming:                            Telco Option:
    Rem Login=                           Allocated Budget(min)= 0
    Rem Password= ********               Period(hr)= 0
  Outgoing:                              Schedule Sets=
    My Login= ?                          Nailed-Up Connection= No
    My Password= ?                     Session Options:
    Authen= CHAP/PAP                     Edit Filter Sets= No
                                         Idle Timeout(sec)= 0

    Press ENTER to Confirm or ESC to Cancel:

              Menu 11.8 - Advance Setup Options

          PPPoE pass-through= No

          Press ENTER to Confirm or ESC to Cancel:

Table 117   Menu 11.8 Advance Setup Options

PPPoE pass-through

Press [SPACE BAR] to select Yes and press [ENTER] to enable PPPoE pass 

through. In addition to the Prestige's built-in PPPoE client, you can enable 

PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client 

software on their computers to connect to the ISP via the Prestige. Each host 

can have a separate account and a public WAN IP address. 
PPPoE pass through is an alternative to NAT for applications where NAT is 

not appropriate.
Press [SPACE BAR] to select No and press [ENTER] to disable PPPoE pass 

through if you do not need to allow hosts on the LAN to use PPPoE client 

software on their computers to connect to the ISP.

When you have completed this menu, press [ENTER] at the prompt “

Press ENTER to Confirm 

or ESC to Cancel:

”  to save your configuration, or press [ESC] at any time to cancel.