ZyXEL VoIP Router Prestige 2602R-61 91-006-024004 Manual Do Utilizador

Prestige 2602R Series User’s Guide

254 

Chapter 25 Remote Node Configuration

The following figure uses sample IP addresses to help you understand the field of My WAN 
Addr in menu 11.3. Refer to the previous 

 in the web configurator 

chapter on LAN setup for a brief review of what a WAN IP is. My WAN Addr indicates the 
local Prestige WAN IP (172.16.0.1 in the following figure) while Rem IP Addr indicates the 
peer WAN IP (172.16.0.2 in the following figure).

Address 

Mapping Set

When Full Feature is selected in the NAT field, configure address mapping sets in 

menu 15.1.  Select one of the NAT server sets (2-10) in menu 15.2 (see 

 for details) and type that number here.

When SUA Only is selected in the NAT field, the SMT uses NAT server set 1 in menu 

 for details).

Metric

The metric represents the cost of transmission for routing purposes. IP routing uses 

hop count as the cost measurement, with a minimum of 1 for directly connected 

networks. Type a number that approximates the cost for this link. The number need 

not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good 

number.

Private

This determines if the Prestige will include the route to this remote node in its RIP 

broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. 

If No, the route to this remote node will be propagated to other hosts through RIP 

broadcasts.

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP Direction.  Options are 

Both, In Only, Out Only or None.

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version.  Options are RIP-1, 

RIP-2B or RIP-2M.

Multicast

IGMP-v1 sets IGMP to version 1, IGMP-v2 sets IGMP to version 2 and None disables 

IGMP.

IP Policies

You can apply up to four IP Policy sets (from 12) by typing in their numbers separated 

by commas. Configure the filter sets in menu 25 first (see 

and then apply them here.

When you have completed this menu, press [ENTER] at the prompt “

Press ENTER to Confirm 

or ESC to Cancel:

”  to save your configuration, or press [ESC] at any time to cancel.

Table 85   Menu 11.3 Remote Node Network Layer Options (continued)