HP A2Y15AV Manual Do Utilizador
Processor Configuration Registers
102
Datasheet, Volume 2
2.6.22
INTRLINE—Interrupt Line Register
This register contains interrupt line routing information. The device itself does not use
this value; rather, it is used by device drivers and operating systems to determine
priority and vector information.
this value; rather, it is used by device drivers and operating systems to determine
priority and vector information.
2.6.23
INTRPIN—Interrupt Pin Register
This register specifies which interrupt pin this device uses.
B/D/F/Type:
0/1/0–2/PCI
Address Offset:
3Ch
Reset Value:
00h
Access:
RW
Size:
8 bits
Bit
Access
Reset
Value
RST/
PWR
Description
7:0
RW
00h
Uncore
Interrupt Connection (INTCON)
This field is used to communicate interrupt line routing
This field is used to communicate interrupt line routing
information.
BIOS Requirement: POST software writes the routing
BIOS Requirement: POST software writes the routing
information into this register as it initializes and configures the
system. The value indicates to which input of the system
interrupt controller this device's interrupt pin is connected.
B/D/F/Type:
0/1/0–2/PCI
Address Offset:
3Dh
Reset Value:
01h
Access:
RW-O, RO
Size:
8 bits
Bit
Access
Reset
Value
RST/
PWR
Description
7:3
RO
00h
Uncore
Reserved (RSVD)
2:0
RW-O
1h
Uncore
Interrupt Pin (INTPIN)
As a multifunction device, the PCI Express device may specify
As a multifunction device, the PCI Express device may specify
any INTx (x=A,B,C,D) as its interrupt pin.
The Interrupt Pin register indicates which interrupt pin the device
The Interrupt Pin register indicates which interrupt pin the device
(or device function) uses.
A value of 1 corresponds to INTA# (Default)
A value of 2 corresponds to INTB#
A value of 3 corresponds to INTC#
A value of 4 corresponds to INTD#
Devices (or device functions) that do not use an interrupt pin
A value of 1 corresponds to INTA# (Default)
A value of 2 corresponds to INTB#
A value of 3 corresponds to INTC#
A value of 4 corresponds to INTD#
Devices (or device functions) that do not use an interrupt pin
must put a 0 in this register.
The values 05h through FFh are reserved.
This register is write once. BIOS must set this register to select
The values 05h through FFh are reserved.
This register is write once. BIOS must set this register to select
the INTx to be used by this root port.