Philips DCM2055 DCM2055/37 Manual Do Utilizador
Códigos do produto
DCM2055/37
20
EN
8 Troubleshooting
Warning
Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
% [ J* " ! !
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
the system yourself.
If you encounter problems when using this
device, check the following points before
% [ J* " ! !
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
>
Ensure that the AC power plug of the unit
is connected properly.
is connected properly.
>
Ensure that there is power at the AC
outlet.
outlet.
>
To save power, the system switches off
automatically 15 minutes after track
play reaches the end and no control is
operated.
automatically 15 minutes after track
play reaches the end and no control is
operated.
No sound or poor sound
>
Adjust the volume.
>
Disconnect the headphones.
No response from the unit
>
Disconnect and reconnect the AC power
plug, then turn on the unit again.
plug, then turn on the unit again.
>
As a power-saving feature, the system
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
switches off automatically 15 minutes after
track play reaches the end and no control
is operated.
Remote control does not work
>
=
=
"
&
select the correct source with the remote
control instead of the main unit.
select the correct source with the remote
control instead of the main unit.
>
Reduce the distance between the remote
control and the unit.
control and the unit.
>
Insert the battery with its polarities (+/–
signs) aligned as indicated.
signs) aligned as indicated.
>
Replace the battery.
>
Aim the remote control directly at the
sensor on the front of the unit.
sensor on the front of the unit.
No disc detected
>
Insert a disc.
>
Check if the disc is inserted upside down.
>
Wait until the moisture condensation at
the lens has cleared.
the lens has cleared.
>
Replace or clean the disc.
>
>
!
*
&
>
!"
device has exceeded a certain limit. This
phenomenon is not a malfunction.
device has exceeded a certain limit. This
phenomenon is not a malfunction.
>
!
supported.
supported.
USB device not supported
>
The USB device is incompatible with the
unit. Try another one.
unit. Try another one.
Poor radio reception
>
Increase the distance between the unit and
your TV or VCR.
your TV or VCR.
>
Fully extend the FM antenna.
Timer does not work
>
Set the clock correctly.
>
Switch on the timer.
Clock/timer setting erased
>
Power has been interrupted or the power
cord has been disconnected.
cord has been disconnected.
>
Reset the clock/timer.