Toshiba 256 Manual Do Utilizador

88    Using Scan Templates

For the models below, press [PREVIEW] and then [SCAN] to preview your scans.
-

e-STUDIO4540C Series

-

e-STUDIO6550C Series

-

e-STUDIO2550C Series (only when the hard disk is installed)

 P.56 “Previewing Scans”

y

The above screen is not displayed under the following conditions:
-

You scan the original from the Reversing Automatic Document Feeder without pressing [CONTINUE] to 
scan additional originals.

-

A scan preview is displayed.

y

To cancel the operation, press [JOB CANCEL].

y

To change the scan settings, press [SCAN SETTING].

 P.46 “Changing Scan Settings”

y

When the equipment has scanned more than 1000 pages in a job, the “The number of originals exceeds the 
limit. Do you want to save stored originals?” message appears. If you want to save the scans, press [YES].
If no hard disk is installed in the equipment, scanned originals cannot be saved in the equipment, however 
scanning can be performed until its memory is full. For the approximate number of pages which can be 
scanned, see the following section:

 P.18 “Scan to File”

y

When the temporary workspace is full on the equipment’s hard disk, a message appears and the job is 
canceled. The available workspace can be viewed on the TopAccess [Device] tab.

y

If the number of jobs waiting to store scans in the equipment’s hard disk exceeds 20, a message appears to 
indicate that the equipment’s memory is full. In this case, wait a while until memory becomes available again 
or delete unnecessary jobs from [JOB STATUS].

 P.42 “Viewing the scan job status”