Toshiba ik-hd5e Manual Do Utilizador

Due to the lens used or the environmental condition, color shading may occur at the upper and lower edge of the 
screen. If this happens, the shading correction function can be used to decrease the amount of color shading. For 
shading correction of the unit, SET (Automatic shading correction), MANUAL (Manual shading correction), and OFF 
(no shading correction) modes are provided. Select the mode on the OPTION 1 menu. (Refer to the item “7.2 (8) (8.1) 
Changing shading correction mode”.)

1

  SET (Auto shading) 

•  If the color bar pattern is displayed on the screen or if the index menu/menu is displayed, press the [DISP] button 

to remove them from the screen.

•  Push the [MENU UP] button for approx. 1 second.
•  When the automatic shading correction operation starts, the character SHD blinks on the screen.
•  When the automatic shading correction operation terminates, the character SHD ends blinking and the result is 

displayed for approx. 1 second.

Automatic shading correction operation fi nished correctly.

Automatic shading correction operation fi nished, however, the correction necessary exceeds 
the camera’s range so the maximum possible value is applied. 

Automatic shading correction cannot be performed because the video level is too low. Adjust 
the video level by increasing the illumination or opening the lens iris.

Automatic shading correction cannot be performed because the video level is too high. Adjust 
the video level by decreasing the illumination or closing the lens iris.

2

  MANUAL (Manual Shading)

Perform the correction on the OPTION 1 menu, confi rming with a monitor or a vector scope.
(Refer to the “7.2 (8) (8.2) Changing manual shading correction mode”.)

3

  OFF

No shading correction is performed.

*  Shading correction is only effective when the lens iris and zoom ratio is fi xed. Use the unit with SHADING OFF for 

variable lens conditions.

Note:
Implement shading correction after white balance adjustment by shooting a white object that fi lls the screen in 
the proper video level. 

1

 Switching of I/P modes

The image output can be changed between “1080p” and “1080i” by turning on the power supply while pushing the 
[DATA UP] or [DATA DOWN] button.
•  Turn on the power supply while pushing the [DATA UP] button. The image output becomes “1080p”, and “1080p” 

is displayed on the monitor screen.

•  Turn on the power supply while pushing the [DATA DOWN] button. The image output becomes “1080i”, and 

“1080i” is displayed on the monitor screen.

2

 Switching of vertical frequency

Adjust the FORMAT switch to the “59.94” position for switching to “59.94Hz”.
Adjust the FORMAT switch to the “50” position for switching to “50Hz”.
(Refer to the item “4. NAMES AND FUNCTIONS, 

18

 FORMAT switch”.)