TP-LINK TL-SG2216 Manual Do Utilizador

 

112

 

system power limit, the PD linked to the port with lower priority will be 

disconnected. By default, the priority level is “low”. 

Interface Configuration Mode (interface gigabitEthernet / interface range 

gigabitEthernet) 

Configure the PoE priority as “low” for port 2: 

TL-SG2424P(config)# interface gigabitEthernet 1/0/2 

TL-SG2424P(config-if)# power inline priority low 

The power inline supply command is used to configure the PoE status of the 

corresponding port. 

power inline supply { enable | disable } 

enable | disable —— The PoE status of the port. By default, the PoE status is 

“enable”. 

Interface Configuration Mode (interface gigabitEthernet / interface range 

gigabitEthernet) 

Enable the PoE feature for port 2: 

TL-SG2424P(config)# interface gigabitEthernet 1/0/2 

TL-SG2424P(config-if)# power inline supply enable 

The  power inline profile command is used to bind a PoE profile to the 

corresponding port. To cancel the bind relation, please use no power inline 

profile command.