TP-LINK TL-WA860RE Manual Do Utilizador

Página de 42
TL-WA860RE 
300Mbps WiFi Range Extender with Power Outlet Pass-through 
 
 
LED Explanation: 
Name 
Status 
Indication 
Signal   
 
Off 
TL-WA860RE isn't connected to the router. 
Blinking Green  TL-WA860RE is connecting to the router. 
Solid Green 
TL-WA860RE is connected to the router and is in a good location. 
Blinking Orange  TL-WA860RE is connected to the router but is too far away from 
the router. 
Solid Orange 
TL-WA860RE is connected to the router but is too close to the 
router. 
Ethernet 
 
Off 
No device is connected to ETHERNET port. 
Green 
A device is connected to the ETHERNET port. 
Power 
 
Off 
TL-WA860RE is off. 
Orange 
TL-WA860RE is booting. 
Green 
TL-WA860RE is on. 
Table 1-1 
 
RESET: This button is used to restore the Range Extender’s factory default settings.   
There are two ways to reset the Range Extender’s factory defaults: 
 
Option One: With the Range Extender powered on, press and hold the RESET button for 2 
seconds. Wait 5 seconds until all the LEDs flash once. And then wait the Range Extender to 
reboot to its factory default settings. 
 
Option Two: Restore the default settings from “System Tools > Factory Defaults” of the 
Range Extender's Web-based management page. 
 
  (RANGE EXTENDER/WPS):  If your Wireless  router  or AP supports WPS or QSS 
function, you can press the WPS or QSS button and then press the RANGE EXTENDER 
button to establish a secure connection between the Wireless router (or AP) and the Range 
Extender TL-WA860RE. 
 
ON/OFF: The switch for the power. 
 
ETHERNET: One 10/100Mbps RJ45 Ethernet port used to add wireless connectivity to an 
Ethernet-enabled device such as Internet TV, DVR, Gaming console and so on. Please note 
that this port is not allowed to be connected with router or AP.