Tunturi F330 Manual Do Utilizador

Connect the upper and lower meter wires together 
and push the tension cable into the upright post 
prior to fi tting the upright post to the main frame. 
Secure the upright post to the main frame with 
four chromed washers and Allen screws. Ensure 
that the concave side of the washer faces the 
handlebar support tube. First turn all the screws 
loosely into place and then tighten them.

Make sure the display window shows 8 on the 
knob. Remove the attachment screw and pull out 
the resistance knob from upright post. Pull the 
end of the resistance wire out from the handlebar 
support tube and connect the resistance wire to 
the lower end of the brake wire. Make sure the 
resistance wire is tightly inserted. Push the wire 
inside the handlebar support tube, place the 
resistance knob over the hole in the tube and 
attach it with the screw.

Pop open the battery cover at the back of the meter 
to assemble batteries. Close the cover. Remove the 
cable ties from the wires of the handlebar support. 
Connect the wires to the respective connectors 
on the meter and then thread the wires into the 
handlebar. Be careful not to damage the wires 
when attaching the interface. Slide the meter on 
the top of the handlebar support tube and attach 
it with three locking screws through the plastic 
sleeve. 

Attach the seat to the seat support: tighten the 
locking nuts in opposite directions. Please note 
that you can adjust both seat inclination and the 
distance of the seat from the handlebar. Once the 
distance and inclination are set how you want, 
tighten the locking nuts carefully.

chrome

E340

E340

black