Turbosound TCS-C50T Manual Do Utilizador

 
 

 

If any of the drive units in your TCS series product should cease functioning and need a 
replacement re-cone or diaphragm, you are advised to remove the faulty unit from the 
installation, remove the faulty drive unit(s) and send it to a professional service centre 
authorised to repair Turbosound loudspeakers. 

Removal of the low frequency woofer 
The perforated steel loudspeaker grille is a push fit in the loudspeaker frame. To remove 
the grille, using a pointed object such as a pin inserted through the mesh of the grille, 
gently lever the grille away from the frame. Set the grille aside for later re-assembly. 

Undo the screws holding the back can in place and place to one side. The low frequency 
drive unit will be accessible once the line transformer has been removed from the back of 
the loudspeaker frame. Make a note of the driver terminal polarity for later reconnection. 
Disconnect the cables from the drive unit and completely remove the driver from the 
speaker being careful not to damage the cone or suspension.  Do not place the driver 
near to any equipment or media that may be adversely affected by strong magnetism, 
e.g. CRT monitors or tape of any kind. 

Removal of the high frequency tweeter 
Disconnect the cables from the tweeter, making a note of the driver polarity for later 
reconnection. Undo the screws holding the tweeter in place and carefully lift it out and 
away from the speaker. Do not place the driver near to any equipment or media that may 
be adversely affected by strong magnetism, e.g. CRT monitors or magnetic tape of any 
kind. 

To reinstate the driver(s) simply reverse the above procedure, making sure you observe 
the correct polarity when reconnecting the cables back into the terminals of the drive 
units.