Kenwood KDC-348U Manual Do Utilizador

This equipment may generate or use radio 

frequency energy. Changes or modifications 

to this equipment may cause harmful 

interference unless the modifications are 

expressly approved in the instruction manual. 

The user could lose the authority to operate 

this equipment if an unauthorized change or 

modification is made.

This equipment has been tested and found 

to comply with the limits for a Class B digital 

device, pursuant to Part 15 of the FCC 

Rules.  These limits are designed to provide 

reasonable protection against harmful 

interference in a residential installation.  This 

equipment may cause harmful interference 

to radio communications, if it is not 

installed and used in accordance with the 

instructions.  However, there is no guarantee 

that interference will not occur in a particular 

installation.  If this equipment does cause 

harmful interference to radio or television 

reception, which can be determined by 

turning the equipment off and on, the user is 

encouraged to try to correct the interference 

by one or more of the following measures:

 

■

Reorient or relocate the receiving antenna.

 

■

Increase the separation between the 

equipment and receiver.

 

■

Connect the equipment into an outlet on 

a circuit different from that to which the 

receiver is connected.

 

■

Consult the dealer or an experienced radio/

TV technician for help.

 

■

Contains Transmitter Module

FCC ID : RKXCK5000NVIA

 

■

Contains Transmitter Module

IC : 5119A-CK5000NVIA

Operation is subject to the following two 

conditions:

(1)  This device may not cause interference, and 

(2)  this device must accept any interference, 

including interference that may cause 

undesired operation of the device.

The term “IC: ” before the certification/

registration number only signifies that the 

Industry Canada technical specification were 

met.

L’utilisation de ce dispositif est autorisée 

seulement aux conditions suivantes:

(1) Il ne doit pas causer d’interférence, et 

(2)  l’utilisateur doit accepter tout brouillage, 

y compris les interférences pouvant 

compromettre le fonctionnement de cet 

appareil.

L’expression “IC: ” avant le numéro 

d’homologation/enregistrement signifie 

seulement que les spécifications techniques 

d’Industry Canada ont été respectées.

2CAUTION

Use of controls or adjustments or performance 

of procedures other than those specified 

herein may result in hazardous radiation 

exposure. 

In compliance with Federal Regulations, 

following are reproductions of labels on, or 

inside the product relating to laser product 

safety. 

Kenwood Corporation 

2967-3, ISHIKAWA-MACHI,

HACHIOJI-SHI

TOKYO, JAPAN

KENWOOD CORP. CERTIFIES THIS EQUIPMENT 

CONFORMS TO DHHS REGULATIONS N0.21 CFR 

1040. 10, CHAPTER 1, SUBCHAPTER J.

Location : Top Panel

B64-4798-10_01_K.indb   110

B64-4798-10_01_K.indb   110

11/01/06   15:07

11/01/06   15:07