ONKYO TX-NR1000 Manual Do Utilizador

 

46

 

In this situation, you will need to use a commercially 
available IR emitter. Connect the mini plug of the IR 
emitter to the IR OUT terminal on the TX-NR1000/
TX-NR5000E and then place the IR emitter on the 
remote sensor of the component or facing it. When the 
IR emitter is connected, only the signal input to the IR 
IN terminal is output to the IR OUT terminal. The sig-
nal input from the remote sensor on the front of the 
TX-NR1000/TX-NR5000E will not be output to the IR 
OUT terminal.

 

When you place the IR receiver in the main room, con-
nect the cable from the connecting block to the IR OUT 
MAIN terminal. When you place the IR receiver in the 
remote zone, connect the cable from the connecting 
block to the ZONE 2 or ZONE 3 terminal accordingly. 

 

You can automatically turn on the connected AV com-
ponents with the output signal from the TX-NR1000/
TX-NR5000E’s 12V TRIGGER OUT terminal.

 

Connect the 12V TRIGGER OUT terminal on the 
TX-NR1000/TX-NR5000E to the 12V TRIGGER IN 
terminal on other components. Every 12V TRIGGER 
OUT terminal can be connected to the components 
whether they are placed in the main room, Zone 2, or 
Zone 3.
The TX-NR1000/TX-NR5000E has five 12V TRIG-
GER OUT terminals and the maximum currents to be 
connected are as follows:

 

200 mA

 

 100 mA

After making connections, configure the association 
between the room (zone) and the component to be 
turned on (Refer to “12V Trigger Assign” under “Input 
Setup” on page 98).