ONKYO TX-SR 803E Manual Do Utilizador

 

79

 

■

 

With this preference, you can specify the volume setting 
to be used when the AV receiver is turned on.
When the Volume Display preference is set to Absolute, 
the range is 0 to 100. When it’s set to Relative, the range 
is –

 

∞

 

 dB, –81 dB to +18 dB.

To use the same volume level as when the AV receiver 
was turned off, select “Last.”
The “Power On Vol” cannot be set higher than the “Max-
imum Vol” setting.

 

■

 

With this preference, you can specify the headphone vol-
ume relative to the main volume. This is useful if there’s 
a volume difference between your speakers and your 
headphones. The headphones level can be set from 
–12 dB to +12 dB.

 

■

 

If the text in the onscreen setup menus flickers due to 
compatibility issues with your TV or projector, select 
Non-Interlaced.

 

Default.

 

Select if the menu text flickers.

With some TVs or projectors, the onscreen setup menus 
may not appear when “Non-Interlaced” is selected. In 
this case, select this setting again by using the AV 
receiver’s display, and select “Interlaced.”

 

These settings determine how the operation details are 
displayed.

 

■

 

This preference determines whether operation details are 
displayed onscreen when an AV receiver function is 
adjusted.

 

Displayed (default).

 

Not displayed.

Even when On is selected, operation details are not out-
put if the input source is connected to a COMPONENT 
VIDEO IN or HDMI IN.

 

■

 

With this preference, you can specify the aspect ratio of 
your TV so that the operation details are displayed prop-
erly.

 

Select if your TV is 4:3 (default).

 

Select if your TV is 16:9.

 

■

 

This preference determines where on the screen opera-
tion details are displayed.

 

Bottom of the screen (default).

 

Top of the screen.

 

With this preference, you can specify the position of the 
onscreen setup menus. This is useful with TVs or projec-
tors where the menus don’t appear in the center of the 
screen, or part of the menu is cut off. 
To set the menu position, use the arrow [

]/[

]/ 

[

]/[

] buttons. To set it back to its default position, 

press [ENTER].

 

■

 

This preference determines whether audio received at 
the HDMI IN is output by the HDMI OUT. You may 
want to turn this preference on if your TV is connected 
to the HDMI OUT and you want to listen to the audio 
from a component that’s connected to an HDMI IN, 
through your TV’s speakers. Normally, this should be set 
to Off.

 

 HDMI audio is not output (default).

 

 HDMI audio is output.

With some TVs and input signals, no sound may be out-
put even when this setting is set to On.

 

■

 

With this preference, you can protect your settings by 
locking the setup menus.
When the setup menus are locked, you can still make 
changes to the settings, but they will not be stored, and 
the AV receiver will revert to the original settings next 
time it’s turned on.

 

Setup menus locked.

 

Setup menus not locked.

TX-SR803_En.book Page 79 Friday, August 26, 2005 9:26 AM