Nikon S1100pj Manual Do Utilizador

Tec

h

nica

l N

otes and 

Ind
e

x

If the camera fails to function as expected, check the list of common problems 
below before consulting your retailer or Nikon-authorized service representative.

Problem

Cause/Solution

A

Monitor is blank.

• Camera is off.
• Battery is exhausted.
• Standby mode for saving power: press the 

power switch, the shutter-release button, A 
button, 

c button, or b (movie-record) 

button.

• When flash lamp blinks, wait until flash has 

charged.

• Camera and computer are connected via USB 

cable.

• Camera and TV are connected via audio/video 

cable.

• The monitor turns off when using the remote 

control to operate the camera in projector 
mode.

21
26
21, 153

35

132

129

163

Monitor is hard to read.

• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.

148
177

Camera turns off without 
warning.

• Battery is exhausted.
• Camera has turned off automatically to save 

power.

• The camera has become hot due to the heat 

of the projector. Leave the camera off until it 
has cooled and then turn it on again.

• The camera and battery may not work 

properly at low temperatures.

26
153

164, 
181

176

Date and time of recording are 
not correct.

• If camera clock has not been set, “Date not 

set” indicator blinks during shooting and 
movie recording. Pictures and movies 
recorded before clock is set are dated “00/00/
0000 00:00” or “01/01/2010 00:00” 
respectively. Set the correct time and date 
from the Date option in the setup menu.

• Check camera clock regularly against more 

accurate timepieces and reset as required.

22, 145

145

No indicators displayed in 
monitor.

Playback is set to Auto info for Monitor 
settings in the setup menu.

148

Date imprint not available.

Date setting is not applied in the setup menu.

22, 145