Philips Cube micro sound system DCM1070 DCM1070/05 Manual Do Utilizador

20

EN

9 Troubleshooting

Warning

 

&

Never remove the casing of this apparatus.

To keep the warranty valid, never try to repair 
the system yourself. 
If you encounter problems when using this 
apparatus, check the following points before 
$ @ ;<    ! 
unsolved, go to the Philips web site (www.
philips.com/welcome). When you contact 
Philips, ensure that the apparatus is nearby 
and the model number and serial number are 
available.

No power

 

<

Ensure that the AC power plug of the unit 
is connected properly.

 

<

Ensure that there is power at the AC 
outlet.

 

<

To save power, the unit switches to 
standby automatically 15 minutes after 
a play reaches the end and no control is 
operated.

No sound

 

<

Adjust the volume.

No response from the unit

 

<

Disconnect and reconnect the AC power 
plug, then turn on the unit again.

Remote control does not work

 

<

>  @ ?    ! % 
select the correct source with the remote 
control instead of the main unit.

 

<

Reduce the distance between the remote 
control and the unit.

 

<

Insert the battery with its polarities (+/– 
signs) aligned as indicated.

 

<

Replace the batteries.

 

<

Aim the remote control directly at the 
sensor on the front of the unit.

No disc detected

 

<

Insert a disc.

 

<

Check if the disc is inserted with the print 
side facing inward.

 

<

Wait until the moisture condensation at 
the lens has cleared.

 

<

Replace or clean the disc.

 

<

‚   Zˆ      <

%   )"= 

 

<

 !        ‚>
device has exceeded a certain limit. This 
phenomenon is not a malfunction.

 

<

        
supported.

USB device not supported

 

<

The USB device is incompatible with the 
unit. Try another one.

Poor radio reception

 

<

Increase the distance between the unit and 
your TV  or VCR.

 

<

Fully extend and adjust the FM antenna.

Timer does not work

 

<

Set the clock correctly.

 

<

Switch on the timer.

Clock/timer setting erased

 

<

Power has been interrupted or the power 
cord has been disconnected. 

 

<

Reset the clock/timer.