ZyXEL Prestige 660HW-D1 Wireless Router 91-004-593003B Manual Do Utilizador

P-660H/HW-D Series User’s Guide

Chapter 7 Wireless LAN

120

In a wireless network, the wireless clients must have the same SSID and security settings as 
the access point (AP) or wireless router (we will refer to both as “AP” here) in order to 
associate with it. Traditionally this meant that you had to configure the settings on the AP and 
then manually configure the exact same settings on each wireless client.

OTIST (One-Touch Intelligent Security Technology) allows you to transfer your AP’s SSID 
and WPA-PSK security settings to wireless clients that support OTIST and are within 
transmission range. You can also choose to have OTIST generate a WPA-PSK key for you if 
you didn’t configure one manually.

Note: OTIST replaces the pre-configured wireless settings on the wireless clients.

You must enable OTIST on both the AP and wireless client before you start transferring 
settings.

Note: The AP and wireless client(s) MUST use the same Setup key.

802.11 Mode

Select 802.11b Only to allow only IEEE 802.11b compliant WLAN devices to 

associate with the ZyXEL Device.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN devices to 

associate with the ZyXEL Device.
Select Mixed to allow either IEEE802.11b or IEEE802.11g compliant WLAN devices 

to associate with the ZyXEL Device. The transmission rate of your ZyXEL Device 

might be reduced.

Enable 802.11g+ 

mode

Select the Enable 802.11g+ mode checkbox to allow any ZyXEL WLAN devices 

that support this feature to associate with the ZyXEL Device at higher transmission 

speeds. This permits the ZyXEL Device to transmit at a higher speed than the 

802.11g Only mode.

Max. Frame 

Burst

Enable Maximum Frame Burst to help eliminate collisions in mixed-mode networks 

(networks with both IEEE 802.11g and IEEE 802.11b traffic) and enhance the 

performance of both pure IEEE 802.11g and mixed IEEE 802.11b/g networks. 

Maximum Frame Burst sets the maximum time, in micro-seconds, that the ZZyXEL 

Device transmits IEEE 802.11g wireless traffic only. 
Type the maximum frame burst between 0 and 1800 (650, 1000 or 1800 

recommended). Enter 0 to disable this feature.

Back

Click Back to return to the previous screen.

Apply

Click Apply to save your changes back to the ZyXEL Device.

Cancel

Click Cancel to reload the previous configuration for this screen.

Table 37   Wireless LAN: Advanced