ZyXEL Prestige 660HW-D1 Wireless Router 91-004-593003B Manual Do Utilizador

P-660H/HW-D Series User’s Guide

Appendix G Command Interpreter

298

The following describes how to use the command interpreter. You can telnet to access the CLI 
(Command Line Interface) on the ZyXEL Device. See the included disk or zyxel.com for 
more detailed information on these commands.

Note: Use of undocumented commands or misconfiguration can damage the unit and 

possibly render it unusable.

Use the following steps to telnet into your ZyXEL Device.

1 Connect your computer to the ETHERNET port on the ZyXEL Device.

2 Make sure your computer IP address and the ZyXEL Device IP address are on the same 

subnet. In Windows, click Start (usually in the bottom left corner), Run and then type  

telnet 192.168.1.1

 (the default ZyXEL Device IP address) and click OK.

3 A login screen displays. Enter the default admin password "1234".

• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>. 
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.

For example,

sys filter netbios config <type> <on|off>

means that you must specify the type of netbios filter and whether to turn it on or off.

A list of valid commands can be found by typing help or? at the command prompt. Always 

type the full command. Type exit to log out of the CLI when finished.