Philips Micro music system DCM2020 DCM2020/05 Manual Do Utilizador

Códigos do produto

DCM2020/05

Turn on

Press .

The unit switches to the last selected

source.

Switch to standby mode

Press again to switch the unit to standby

mode.

The clock (if set) is displayed.

To switch to Eco power standby mode:

Press and hold for more than two seconds.

The backlight on the display panel

turns off.

To switch between normal standby mode and

Eco power standby mode:

Press and hold for more than two seconds.

Note

•

If no button is pressed over 15 minutes in standby

mode, this device goes to Eco power standby mode

automatically.

Set clock
1

In standby mode, press and hold

PROG/CLOCK SET for more than two

seconds to activate clock setting mode.

[CLOCK SET] (clock set) scrolls on

the display, and then the time format

[24H] and [12H] is displayed.

Press / to select 24H or 12H, and

then press PROG/CLOCK SET.

The hour digits begin to blink.

Press / to set hour, and then press

PROG/CLOCK SET again.

The minute digits begin to blink.

Press / to set minute.

Prepare the remote control

Caution

•

Risk of explosion! Keep batteries away from heat,

sunshine, or fire. Never discard batteries in fire.

To insert the remote control battery:

Open the battery compartment.

Insert 2 AAA batteries with correct

polarity (+/-) as indicated.

Close the battery compartment.

Note

•

If you are not going to use the remote control for a

long time, remove the batteries.

•

Do not use old and new or different types of batteries

in combination.

•

Batteries contain chemical substances, so they should

be disposed of properly.