ZyXEL Wireless Access Point G1000 91-005-124003B Manual Do Utilizador
Códigos do produto
91-005-124003B
G-1000 User’s Guide
Chapter 6 Wireless LAN
57
To enable roaming on your G-1000, click the WIRELESS link under ADVANCED and then
the Roaming tab. The screen appears as shown.
the Roaming tab. The screen appears as shown.
Figure 16 Roaming
The following table describes the labels in this screen.
6.5 MAC Filter
The MAC filter screen allows you to configure the G-1000 to give exclusive access to up to 32
devices (Allow Association) or exclude up to 32 devices from accessing the G-1000 (Deny
Association). Every Ethernet device has a unique MAC (Media Access Control) address. The
MAC address is assigned at the factory and consists of six pairs of hexadecimal characters, for
example, 00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure
this screen.
devices (Allow Association) or exclude up to 32 devices from accessing the G-1000 (Deny
Association). Every Ethernet device has a unique MAC (Media Access Control) address. The
MAC address is assigned at the factory and consists of six pairs of hexadecimal characters, for
example, 00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure
this screen.
The WLAN Adapter drop down list box is only available when you have an external wireless
card inserted in the G-1000. No matter whether you select Built-in or Removable, the
configuration screens are the same for each interface.
card inserted in the G-1000. No matter whether you select Built-in or Removable, the
configuration screens are the same for each interface.
To change your G-1000’s MAC filter settings, click the WIRELESS link under
ADVANCED and then the MAC Filter tab. The screen appears as shown.
ADVANCED and then the MAC Filter tab. The screen appears as shown.
Table 14 Roaming
LABEL
DESCRIPTION
Active
Select Yes from the drop-down list box to enable roaming on the G-1000 if you
have two or more G-1000s on the same subnet.
Note: All APs on the same subnet and the wireless stations must
have the same ESSID to allow roaming.
have the same ESSID to allow roaming.
Port #
Enter the port number to communicate roaming information between access
points. The port number must be the same on all access points. The default is
3517. Make sure this port is not used by other services.
Apply
Click Apply to save your changes back to the G-1000.
Reset
Click Reset to begin configuring this screen afresh.