Philips Micro music system DCM2055 DCM2055/05 Manual Do Utilizador
Códigos do produto
DCM2055/05
10
EN
Set clock
1
1
In standby mode, press and hold CLOCK
SET on the remote control for two
seconds.
»
[SET CLOCK] (set clock) scrolls on
the display, then the 12/24 hour format
blinks.
2
Press / repeatedly to select an hour
format.
3
Press CLOCK SET to confirm.
»
The hour digits blink.
4
Repeat steps 2-3 to set the hour.
5
Repeat steps 2-3 to set the minute.
6
Repeat steps 2-3 to select whether to
synchronize time on this unit with that on
the RDS stations.
• [RDS TIME SYNC [Y]]: synchronize
time from the RDS stations
automatically.
• [RDS TIME SYNC [N]]: deactivate
time synchronization.
Note
•
The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
•
If no button is pressed in 90 seconds, the unit exits
clock setting mode automatically.
Turn on
Press .
»
The unit switches to the last selected
source.
Note
•
To select a source, press SOURCE repeatedly or the
source selection buttons on the remote control.
Switch to standby mode
Press again to switch the unit to standby
mode.
»
The clock (if set) appears on the display
panel.
Store FM radio stations
automatically
When the unit turns to FM tuner mode, and
no radio stations are stored, the unit begins to
store FM radio stations automatically.
1
Connect the unit to the power supply.
»
[AUTO INSTALL - PRESS PLAY, STOP
CANCEL] (to auto install, press
;
to cancel, press ) is displayed.
2
Press and hold
for 3 seconds to start
full scan.
»
The unit automatically stores FM radio
stations with sufficient signal strength.
»
When all the available radio stations
are stored, the first preset radio station
is broadcast automatically.
Tip
•
To exit storing mode, press or .
DCM2055_05_UM_V1.0_EN.indd 10
9/22/2011 1:45:17 PM