ZyXEL Prestige 792H SDSL Router 91-004-342004B Manual Do Utilizador

Prestige 791R G.SHDSL Router 

IP Policy Routing 

 

33-5 

Len Comp 

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, 
Less, Greater, Less or Equal or Greater or Equal. 

Source:  

addr start / end  Source IP address range from start to end. 

port start / end  Source port number range from start to end; applicable only for TCP/UDP. 

Destination:  

addr start / end  Destination IP address range from start to end. 

port start / end  Destination port number range from start to end; applicable only for TCP/UDP. 

Action 

Specifies whether action should be taken on criteria Matched or Not 
Matched. 

Gateway addr 

Defines the outgoing gateway address. The gateway must be on the same 
subnet as the Prestige if it is on the LAN, otherwise, the gateway must be the 
IP address of a remote node. The default gateway is specified as 0.0.0.0. 

Type of Service 

Set the new TOS value of the outgoing packet. Prioritize incoming network 
traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max 
Reliable or Min Cost. 

Precedence 

Set the new outgoing packet precedence value. Values are 0 to 7 or No 
Change. 

Log 

Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the 
system log when a policy is executed. 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to 
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen. 

This section shows you where to apply the IP policies after you design them. 

From Menu 3 — Ethernet Setup, type 2 to go to Menu 3.2 — TCP/IP and DHCP Ethernet Setup. 

You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for 
example, 2, 4, 7, 9.