Dual CS 415-2 CS415-2 Manual Do Utilizador

1. Dust cover 

  7. Stylus

2. Hinge 

  8. Audio Cinch Plugs

3. Cueing lift lever 

  9. Earth Wire

4. Speed Selector 

10. Connection socket for mains set at 12 V / D.C

5. tonearm support with tonearm lock
6. Automatic start - stop switch

Unpack the unit and all the accessories. Please keep the packaging for future use when transporting the device.
–  Insert the hinges 

 in the appropriate recesses (fig. 1)

–  Slide the cover 

 parallel to the position of the hinges 

 (opening angle approximately 60º) until it locks in  

  position. In this position, the cover can be removed any time.
 

The delivered mains set will be connected to the socket 10. The mains set, corresponding to the voltage 
Indicated on the nameplate has to be plugged in to the power-supply plug (230 V / 50Hz).

–  Connect the audio cables 

 to the phono-magnetic inputs of the phonostage, amplifier or receiver 

  (red RCA-type plug = right channel, white RCA-type plug = left channel).
–  Connect earth wire 9 to the earth connector of you amplifier.

–  The record diameter for the automatic start is also pre-selected when the record speed 33.33 or 45 rpm  

   

  is selected.
–  Remove the stylus guard by pulling it forwards and disengage the tonearm set switch 

 to 

–  The tonearm is lowered automatically onto the record.

–  Select the required platter speed, 33.33 or 45 rpm, by means of the switch 

, swivel the stylus protection  

  cap upwards, set the cueing lever 

 to position 

–  Now position the tonearm over the lead-in groove of the record. The tonearm is now lowered slowly onto  
  the record using the cueing lever 

. The tonearm is lowered slowly, thus preventing damage to your records.

–  The tonearm can be raised at any position, also for brief interruptions when playing, by means of the cue  
  control lever (cueing lever in position     ). The platter continues to rotate in this case.

–  At the end of record, the tonearm is automatically repositioned back on the tonearm post and unit is    
  switched off.
–  You can also switch off the turntable by setting the cueing lever 

3

 to position     and repositioning the    

  tonearm on the tonearm post.

The stylus is subject to natural wear and tear during normal playing. Therefore, we recommend you occasion-
ally check the stylus and, in the case of the diamond styli, this should be carried out after approximately 300 
hours playing hours. Worn or damaged (splintered) styli chisel the modulation from the grooves and destroy 
records. Therefore, only use the stylus types recommended in the techical date of the cartridge as replacement 
cartridges. Imitated styli result in audible quality losses and increased wear and tear of records.
Pull of the stylus slanting downwards, Insert the stylus in the reverse mode (fig. 2)