Zebra HW46211 Manual Do Utilizador
Page 4-78
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Replace the DC Stepper Motor
Remove the DC Stepper Motor
1. Refer to
. Turn the printer Off (O) and remove the AC
power cord and data cables.
2. Open the media cover and remove the media and ribbon.
3. Refer to
and remove the electronics cover.
4. Refer to
and remove the power supply.
5. Refer to
6. Refer to
7. Refer to
, and remove the upper and lower
platen rollers.
Notes • The stepper motor assemblies for 203 dpi and 300 dpi printers are not
the same. Ensure that you have the correct replacement part before beginning
this procedure.
the same. Ensure that you have the correct replacement part before beginning
this procedure.
Make certain that the DC stepper motor is isolated and identified as the cause
of printer nonconformance before beginning this procedure.
of printer nonconformance before beginning this procedure.
These instructions are very extensive. Read the entire procedure first, to get an
understanding of all the steps involved. You may want to take notes and label
parts as you go to facilitate reassembly.
understanding of all the steps involved. You may want to take notes and label
parts as you go to facilitate reassembly.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
Wear protective eyewear when removing E-rings, C-clips, snap rings, and
springs. All of these are under tension and could fly off while being removed.
springs. All of these are under tension and could fly off while being removed.
Caution:
This installation must be performed by a qualified service technician.