Cisco TRC5 CTS-RMT-TRC5= Manual Do Utilizador
Códigos do produto
CTS-RMT-TRC5=
23
Deployment Details
August 2012 Series
23
Step 3:
Configure the port as an access port and apply the QoS policy.
interface
Ethernet107/1/3
description Codian MCU
switchport access vlan
148
spanning-tree port type edge
service-policy type qos input DC-FCOE+1P4Q_INTERFACE-DSCP-QOS
When deploying a dual-homed Nexus 2248, this configuration is
applied to both Nexus 5548s.
applied to both Nexus 5548s.
Tech Tip
Option 2. Connect the MCU to a Catalyst 3750-X
To ensure that video traffic is prioritized appropriately, you must configure
the Catalyst access switch port where the MCU is connected to trust the
DSCP markings. The easiest way to do this is to clear the interface of any
previous configuration and then, apply the egress QoS macro that was
defined in the access-switch platform configuration of the SBA—LAN
To ensure that video traffic is prioritized appropriately, you must configure
the Catalyst access switch port where the MCU is connected to trust the
DSCP markings. The easiest way to do this is to clear the interface of any
previous configuration and then, apply the egress QoS macro that was
defined in the access-switch platform configuration of the SBA—LAN
Deployment Guide.
Step 1:
Login to the Catalyst switch with a username that has the ability to
make configuration changes.
Step 2:
Clear the interface’s configuration on the switch port where the VCS
is connected.
default interface
GigabitEthernet1/0/11
Step 3:
Configure the port as an access port on the same VLAN as the VCS
and apply the Egress QoS policy.
interface
GigabitEthernet1/0/11
description Codian MCU
switchport access vlan
148
switchport host
macro apply EgressQoS
Procedure 2
Prepare the Cisco MCU platform
In the following steps, set the initial configuration by using a PC connected
to the console port with a serial cable.
to the console port with a serial cable.
Step 1:
Ensure power is connected to Cisco MCU and the Status LED is
green.
Step 2:
Connect the Ethernet LAN cable from the Ethernet A port on the
front of the unit to your network.
Step 3:
Connect the console port of Cisco MCU to the serial port of your
PC using the blue RJ45 to DB9 cable supplied.
Step 4:
Use terminal emulation software such as PuTTY and configure the
serial port on the PC as follows:
• Baud rate—
38400
• Data bits—
8
• Parity—
none
• Stop bits—
1
• Flow control—
none
Step 5:
Press
Enter.
The MCU command prompt appears on the terminal.
Step 6:
Configure Ethernet Port A for auto-sensing.
ethertype auto
Step 7:
Assign a static IP address.
static
10.4.48.135 255.255.255.0 10.4.48.1 10.4.48.10
Step 8:
Disconnect the serial cable and store it in a safe place.