IBM Flex System V7000 Expansion Enclosure 4939H29 Manual Do Utilizador

Chapter 4. IBM Flex System V7000 Storage Node Initial Configuration 

Draft Document for Review January 29, 2013 12:52 pm

5. Click Finish Figure 4-11 to set the management IP address for the system. System 

initialization begins and might take several minutes to complete.

When system initialization is complete, System Set Up is launched automatically. The 
setup wizard will take you through the steps to configure basic system settings such as 
time and date, system name, and hardware detection and verification. 

For more details on the rest of the setup wizard steps, please see 4.3, “IBM Flex System 
V7000 Storage Node Setup Wizard” on page 161

After the initial configuration using the FSM or CMM, we can continue with the setup wizard 
for the rest of the configuration of IBM Flex System V7000 Storage Node.

After clicking Finish on Figure 4-11, on the next screen, enter the system name and a new 
superuser password. At this point you have the option to use the setup wizard to configure 
more settings such as notifications and storage configuration. If you are not ready to complete 
more configuration steps now, use the configuration tasks in the management GUI to 
complete the configuration at a later time.

When you complete the Initial Setup wizard, return to the FSM or CMM console.

1. After the initial configuration described in 4.2, “Initial setup for IBM Flex System V7000 

is complete, the IBM Flex System V7000 Storage Node 

Welcome window opens (Figure 4-12 on page 162).

Note: It is recommended that you upgrade to the most current level of software after 
installing the Flex System V7000 Storage Node. The management GUI can be used to 
apply software updates. Refer to the IBM Flex System V7000 Storage Node support 
website for the latest information about software upgrades.