ZyXEL 4-port Prestige 792H Router 91-004-342001 Manual Do Utilizador

Prestige 792H G.SHDSL Router 

WAN   5-17 

PPP Options 

 

Encapsulation

 

Select CISCO PPP from the drop-down list box if your backup WAN device uses 
Cisco PPP encapsulation; otherwise select Standard PPP. 

 

Compression

 

Select this check box to enable stac compression.  

Connection 

 

 

Nailed-Up 

Connection 

Select Nailed-Up Connection when you want your connection up all the time. 
The Prestige will try to bring up the connection automatically if it is disconnected. 

Connect on Demand  Select Connect on Demand when you don't want the connection up all the time 

and specify an idle time-out in the Max Idle Timeout field. 

Max Idle Timeout  Specify an idle time-out in the Max Idle Timeout field when you select Connect 

on Demand. The default setting is 0, which means the Internet session won’t 
timeout. 

Budget 

The configuration in the Budget fields has priority over your Connection 
settings. 

Allocate Budget  Type the amount of time (in minutes) that the dial backup connection can be used 

during the time configured in the Period field. Set an amount that is less than the 
time period configured in the Period field. If you set the Allocated Budget to 0, 
you will not be able to use the dial backup connection. 

Period   Type the time period (in hours) for how often the budget should be reset. For 

example, to allow calls to this remote node for a maximum of 10 minutes every 
hour, set the Allocated Budget to 10 (minutes) and the Period to 1 (hour). If you 
set the Period to 0, there is no budget control and the Prestige uses the 
Connection settings. 

Back 

Click Back to return to the previous screen. 

OK

 

Click OK to return to the previous screen, then click Apply to save the changes. 

 

Cancel

 

Click Cancel to begin configuring this screen afresh.

 

For regular telephone lines, the default “Dial” string tells the modem that the line uses tone dialing. “ATDT” 
is the command for a switch that requires tone dialing. If your switch requires pulse dialing, change the 
string to “ATDP”.