Alcatel-Lucent OS-LS-6248 OS-LS-6248-US Manual Do Utilizador

C-15

Caution:  DO NOT plug a phone jack connector into any RJ-45 port. Use only 

twisted-pair cables with RJ-45 connectors that conform with FCC standards.

For 10BASE-T/100BASE-TX connections, a twisted-pair cable must have two pairs 
of wires. Each wire pair is identified by two different colors. For example, one wire 
might be green and the other, green with white stripes. Also, an RJ-45 connector 
must be attached to both ends of the cable.

Caution: Each wire pair must be attached to the RJ-45 connectors in a specific 

orientation. (See “Cabling Guidelines” on page 3-21 for an explanation.)

The figure below illustrates how the pins on the RJ-45 connector are numbered. Be 
sure to hold the connectors in the same orientation when attaching the wires to the 
pins.

Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45 
connections: 100-ohm Category 3, 4 or 5 cable for 10 Mbps connections or 100-ohm 
Category 5 cable for 100 Mbps connections. Also be sure that the length of any 
twisted-pair connection does not exceed 100 meters (328 feet).

The RJ-45 ports on the switch base unit support automatic MDI/MDI-X operation, 
you can use straight-through cables for all network connections to PCs or servers, or 
to other switches or hubs. In straight-through cable, pins 1, 2, 3, and 6, at one end of 
the cable, are connected straight through to pins 1, 2, 3, and 6 at the other end of 
the cable. When using any RJ-45 port on this switch, you can use either 
straight-through or crossover cable.

8

1

1

8