ZyXEL ADSL Prestige 660HW-61 91-004-361001 Manual Do Utilizador

Prestige 660H/HW Series User’s Guide

Chapter 25 Internet Access

246

.

Menu 4 Internet Access Setup

 

ISP’s Name

Enter the name of your Internet Service Provider (ISP). This information is for 

identification purposes only.

Encapsulation

Press [

SPACE BAR

] to select the method of encapsulation used by your ISP.  

Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.

Multiplexing

Press [

SPACE BAR

] to select the method of multiplexing used by your ISP. 

Choices are VC-based or LLC-based.

VPI #

Enter the Virtual Path Identifier (VPI) assigned to you. 

VCI #

Enter the Virtual Channel Identifier (VCI) assigned to you.

ATM QoS Type

Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify fixed 

(always-on) bandwidth. Select UBR (Unspecified Bit Rate) for applications that are 

non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty traffic 

and bandwidth sharing with other applications.

Peak Cell Rate 

(PCR)

This is the maximum rate at which the sender can send cells. Type the PCR. 

Sustain Cell Rate 

(SCR)= 0

Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source that can 

be sent at the peak rate, and a parameter for burst-traffic. Type the SCR; it must 

be less than the PCR.

Maximum Burst 

Size (MBS)= 0

Refers to the maximum number of cells that can be sent at the peak rate. Type the 

MBS. The MBS must be less than 65535.

My Login

Configure the My Login and My Password fields for PPPoA and PPPoE 

encapsulation only. Enter the login name that your ISP gives you. If you are using 

PPPoE encapsulation, then this field must be of the form user@domain where 

domain identifies your PPPoE service name.

My Password

Enter the password associated with the login name above.

ENET ENCAP 

Gateway

Enter the gateway IP address supplied by your ISP when you are using ENET 

ENCAP encapsulation.

Idle Timeout

This value specifies the number of idle seconds that elapse before the Prestige 

automatically disconnects the PPPoE session. 

IP Address 

Assignment

Press [

SPACE BAR

] to select Static or Dynamic address assignment.

IP Address

Enter the IP address supplied by your ISP if applicable.

Network Address 

Translation

Press [

SPACE BAR

] to select None, SUA Only or Full Feature.  Please see 

 for more details on the SUA (Single User Account) 

feature.

Address Mapping 

Set

Type the numbers of mapping sets (1-8) to use with NAT. See 

 for details.

When you have completed this menu, press [ENTER] at the prompt “

Press ENTER to Confirm 

or ESC to Cancel:

”  to save your configuration, or press [ESC] at any time to cancel.

If all your settings are correct your Prestige should connect automatically to the Internet.  If the 
connection fails, note the error message that you receive on the screen and take the appropriate 
troubleshooting steps.