ZyXEL 791R 91-004-247001B Manual Do Utilizador
Códigos do produto
91-004-247001B
Prestige 791R G.SHDSL Router
8-12
Remote Node TCP/IP Configuration
Do not edit filter sets 11 and 12. They are used exclusively by the web
configurator. Any rules you configured in sets 11 and 12 will be erased and
replaced when you apply the web configurator-generated filter rules.
8.5 Editing ATM Layer Options
Follow these steps to edit Menu 11.6 – Remote Node ATM Layer Options.
Step 1.
In Menu 11.1, move the cursor to the Edit ATM Options then press [SPACE BAR] to toggle
and set the value to Yes.
and set the value to Yes.
Step 2.
Press [ENTER] to open Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of Menu 11.6 for the Prestige, depending on whether you chose VC-based or LLC-
based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.
based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.
8.5.1 VC-based Multiplexing (non-PPP Encapsulation)
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, e.g., VC1
will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.
will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.
Figure 8-11 Menu 11.6 for VC-based Multiplexing (non-PPP Encapsulation)
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
VC Options for IP: VC Options for Bridge:
VPI #= 0 VPI #= N/A
VCI #= 38 VCI #= N/A
ATM QoS Type= UBR ATM QoS Type= N/A
Peak Cell Rate (PCR)= 0 Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= 0 Sustain Cell Rate (SCR)= N/A
Sustain Cell Rate (SCR)= 0 Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBS)= 0 Maximum Burst Size (MBS)= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Separate VPI and
VCI numbers must
be specified.