Hunter Total Air Sanitizer 30890 Manual Do Utilizador

4

44068-01  •  11/11/2011

1.  Take the Total Air Sanitizer out of the box and remove 

the clear plastic protective bag and place the unit on a 

firm, level surface.

2.  Before turning on the Total Air Sanitizer, you need to confirm 

that the filter tis firmly in place and has not become loose 

during shipping. To release the door, push down on the 

Hunter

®

 logo on the door to release the front grill. Figure 1.

3.  Gently pull the door away from the unit and lift away. 

Figure 2.

4.  The HEPA

®

 Filter will be resting inside the unit. The  filter 

will say “This side faces you” to indicate the direction the 

filter should be placed in the unit. Ensure the filter is seated 

fully into the unit by pressing all four corners of the filter. 

Figure 3. In addition, the filter should be secured with the 

filter bracket. Figure 4.

NOTE: If the filter is not seated properly inside the unit, the air 

sanitizer will not operate.

5.  Set the tabs on the each side of the bottom of the door into 

the notches in the base of the unit and rock the door up until 

the top of the door makes contact with the magnet. 

6.  Push the Hunter logo in until the front door “clicks” into place. 

7.  Plug the unit into a 120V electrical outlet.

Operation:
See Figure 5.

OFF - Press the sensor pad until all speed indicator lights are  

           off. This will turn the unit off.
The fan speed can be adjusted at any time by touching the 

sensor pad on the top of the unit.
 

Sensor

Pad

Filter 

Indicator

Indicator

Lights

Low speed - Recommended for use when soft       

   

background noise is unwanted.

Medium speed - Typical usage setting. Soft 

 

      

background noise is not an issue.

High speed - Use when quick, efficient results to a  

     

room’s air quality are desired.

Filter Indicator - When the filter life counter exceeds 4000 

hours, the filter indicator will flash red as a reminder that 

you should check the filter. Touch the sensor pad for 3 

seconds to reset the filter counter.

Filter

Press

Here

Filter

Bracket