ZyXEL Prestige 660HW-61 External 91-004-370001 Manual Do Utilizador

Prestige 660H/HW Series User’s Guide

343

Chapter 38 IP Policy Routing

Figure 222   Menu 25.1.1 IP Routing Policy

The following table describes the fields in this menu.

Menu 25.1.1 - IP Routing Policy

  Policy Set Name= test
  Active= No
  Criteria:
    IP Protocol    = 0
    Type of Service= Don't Care           Packet length= 0
    Precedence     = Don't Care             Len Comp= N/A
    Source:
      addr start= 0.0.0.0                 end= N/A
      port start= N/A                     end= N/A
    Destination:
      addr start= 0.0.0.0                 end= N/A
      port start= N/A                     end= N/A
  Action= Matched
    Gateway addr   = 0.0.0.0              Log= No
    Type of Service= No Change
    Precedence     = No Change

Press ENTER to Confirm or ESC to Cancel:

Table 117   Menu 25.1.1 IP Routing Policy

Policy Set Name

This is the policy set name assigned in Menu 25 – IP Routing Policy Setup.

Active

Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to 

deactivate the policy. Inactive policies are displayed with a minus sign “-“ in SMT 

menu 25.

Criteria

IP Protocol

IP layer 4 protocol, for example, UDP, TCP, ICMP, etc.

Type of Service

Prioritize incoming network traffic by choosing from Don’t Care, Normal, Min 

Delay, Max Thruput, Min Cost or Max Reliable.

Precedence

Precedence value of the incoming packet. Press [SPACE BAR] and then 

[ENTER] to select a value from 0 to 7 or Don’t Care.

Packet Length

Type the length of incoming packets (in bytes). The operators in the Len Comp 

(next field) apply to packets of this length.

Len Comp

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, Less, 

Greater, Less or Equal or Greater or Equal.

Source:

addr start / end

Source IP address range from start to end.

port start / end

Source port number range from start to end; applicable only for TCP/UDP.

Destination:

addr start / end

Destination IP address range from start to end.

port start / end

Destination port number range from start to end; applicable only for TCP/UDP.

Action

Specifies whether action should be taken on criteria Matched or Not Matched.