ZyXEL Prestige 660HW-61 External 91-004-370001 Manual Do Utilizador

Prestige 660H/HW Series User’s Guide

97 

Chapter 7 Wireless LAN Setup

Select Authentication Required in the Wireless Port Control field and WPA-PSK in the 
Key Management Protocol field to display the next screen.

Figure 33   Wireless LAN: 802.1x/WPA for WPA-PSK Protocol

The following table describes the labels not previously discussed.

Table 22   Wireless LAN: 802.1x/WPA for WPA-PSK Protocol 

Key Management 

Protocol

Choose WPA-PSK in this field.

Pre-Shared Key

The encryption mechanisms used for WPA and WPA-PSK are the same. The 

only difference between the two is that WPA-PSK uses a simple common 

password, instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including 

spaces and symbols).

WPA Mixed Mode

The Prestige can operate in WPA Mixed Mode, which supports both clients 

running WPA and clients running dynamic WEP key exchange with 802.1x in the 

same Wi-Fi network.
Select the check box to activate WPA mixed mode. Otherwise, clear the check 

box and configure the Group Data Privacy field.

Group Data Privacy Group Data Privacy allows you to choose TKIP (recommended) or WEP for 

broadcast and multicast ("group") traffic if the Key Management Protocol is 

WPA and WPA Mixed Mode is disabled. WEP is used automatically if you have 

enabled WPA Mixed Mode. 
All unicast traffic is automatically encrypted by TKIP when WPA or WPA-PSK 

Key Management Protocol is selected. 

Authentication 

Databases

This field is only visible when WPA Mixed Mode is enabled.