Vogel's PFW 6852 Display wall mount, 136 kg 7368520 Folheto
Códigos do produto
7368520
PFW6852
Page 10
Visit the Vogel’s website at http://www.vogels.com
Installation Instructions
Mounting Hardware Selection
Selecting the Mounting Hardware
Selecting the Mounting Hardware
n
n
Insert a small straw or toothpick into the threaded
inserts found on the back of the flat panel.
n
o
Use a pencil to mark the depth of the threaded
insert on the small straw or toothpick.
n
p
Mark the straw or toothpick 1/8” above the depth of
the threaded insert, as shown in Figure 1.
n
q
Insert the small straw or toothpick into the remaining
threaded inserts to compare and verify their depth
using the straw or toothpick’s 1/8” allowance mark.
n
r
Locate the correct diameter screw for the threaded
insert.
If the screw you selected is longer than the 1/8”
allowance mark on the small straw or toothpick,
as shown in Figure 2 and Figure 3, do not use
this screw. The screw length must not bypass the
mark.
n
s
Test each size of the screws provided.
The correct screws should thread easily into the
mounting point and not pull out when tension is
applied.
You must account for the bracket, spacers and
Griplate™ depths when using the Thread Depth
Indicator to measure the thread depth of your flat
panel.
Proceed to the
“Griplate™ Washer Installation”
section.
Small Straw or Toothpick
Small Straw
or Toothpick
Small Straw
or Toothpick
Marking the 1/8”
Allowance
Depth Plus 1/8” Allowance
Mark
Depth Plus 1/8” Allowance
Mark