Philips HTL7180 HTL7180/F7 Manual Do Utilizador

14

EN

5  Wall mount 

your SoundBar

Before you mount your SoundBar on the wall, 

read all safety precautions.

Wall mount

Note

 

•

You must detach the surround speakers from the main 

unit before wall mounting or un-mounting.

 

•

P&F USA, INC. bears no responsibility for improper 

wall mounting that results in accident, injury or damage. 

If you have any query, contact Philips Consumer Care 

in your country.

 

•

Secure the wall mount to a wall that can support the 

combined weight of the product and the wall mount.

 

•

Before wall mount, you need not remove the four 

rubber feet at the bottom of the soundbar, otherwise 

the rubber feet cannot be fixed back.

Screw length/diameter

Depend on the type of wall mounting this wall 

mount bracket, make sure that you use screws 

of a suitable length and diameter.

  

For information about how to wall your 

SoundBar, see the wall mount guide.

> 25mm

3 - 3.5mm

6 Product 

specifications

Note

 

•

Specifications and design are subject to change without 

notice.

Amplifier

•  FTC total output power: 66W*

•  Front Left + Right: 16W (1% THD, 

8ohm, 150 Hz - 20 kHz)

•  Surround Left + Right: 20W (1% THD, 

8ohm, 150 Hz - 20 kHz)

•  Subwoofer: 30W (1% THD, 4ohm, 30 

Hz - 140 Hz)

•  Total output power: 

•  210W RMS (+/- 0.5 dB, 30% THD) 

•  168W RMS (+/- 0.5 dB, 10% THD)

•  Frequency response: 20 Hz-20 kHz /  

±3 dB

•  Signal-to-noise ratio: > 65 dB (CCIR) / 

(A-weighted)

•  Input sensitivity:

•  AUX: 400 mV

•  AUDIO-IN: 200 mV

* FTC output power is measured in bypass 

mode.  To enter bypass mode, in AUX mode, 

press and hold AUTO VOLUME  OFF for 5 

seconds. To exit bypass mode, turn off the unit 

and switch it on again.

Audio

•  S/PDIF Digital audio input:

•  Coaxial: IEC 60958-3

•  Optical: TOSLINK

Bluetooth

 • Bluetooth profiles: A2DP

HTL7180_F7_UM_V1.1.indb   14

2013/5/14   14:50:01