Alpine CDA-137BTi CDA-137BTI Manual Do Utilizador
Códigos do produto
CDA-137BTI
53
-EN
Installation
Caution
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
1
Remove the mounting sleeve from the main unit (refer to
“Removal” on page 53). Slide the mounting sleeve into the
dashboard and fix it with the metal shackles.
“Removal” on page 53). Slide the mounting sleeve into the
dashboard and fix it with the metal shackles.
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the CDA-137BTi and put the
Rubber Cap on the hex bolt. If your vehicle does not have
the Mounting Support, reinforce the head unit with the
metal mounting strap (not supplied). Connect all other
leads of the CDA-137BTi according to details described in
the CONNECTIONS section.
bolt onto the rear panel of the CDA-137BTi and put the
Rubber Cap on the hex bolt. If your vehicle does not have
the Mounting Support, reinforce the head unit with the
metal mounting strap (not supplied). Connect all other
leads of the CDA-137BTi according to details described in
the CONNECTIONS section.
Note
• For the screw
*
, provide a proper screw to the chassis installing location.
3
Slide the CDA-137BTi into the dashboard. When the unit is
in place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the detachable front panel.
in place, make sure the locking pins are fully seated in the
down position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a small
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the detachable front panel.
1
Remove the detachable front panel.
2
Use a small screwdriver (or similar tool) to push the
locking pins to the “up” position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
locking pins to the “up” position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3
Pull the unit out, keeping it unlocked as you do so.
JAPANESE CAR
Connect USB cable to an iPod/iPhone with Interface cable for iPod.
Detachable Front
Panel
Panel
Less than 35°
Rubber Cap
(Included)
(Included)
Bracket
Hex Bolt
(Included)
(Included)
Mounting Sleeve
(Included)
(Included)
Dashboard
Pressure Plates
*
This unit
*
Metal Mounting Strap
Screw
Bolt Stud
Hex Nut (M5)
This unit
Removal
iPod/iPhone Connection (sold separately)
Lock Pin
Front Frame
Screws (M5 × 8)
(Included)
(Included)
This unit
Mounting Bracket
Interface cable for iPod (supplied)
USB cable