Netgear GS516TP GS516TP-100EUS Manual Do Utilizador
Códigos do produto
GS516TP-100EUS
Installation
21
GS516TP Gigabit Smart Switch
Connect Devices to the Switch
The following procedure describes how to connect computers to the switch’s RJ-45 ports.
The switch contains Auto Uplink technology, which allows the attaching of devices using
either straight-through or crossover cables.
The switch contains Auto Uplink technology, which allows the attaching of devices using
either straight-through or crossover cables.
Figure 5. Connecting devices to the switch
Connect each computer to an RJ-45 network port on the switch front panel. Use a Category 5
(Cat 5) unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector to make
these connections.
(Cat 5) unshielded twisted-pair (UTP) cable terminated with an RJ-45 connector to make
these connections.
Note:
Ethernet specifications limit the cable length between the switch and
the attached device to 100 meters (328 feet).
the attached device to 100 meters (328 feet).
To connect devices to the switch:
1.
Connect a Cat 5 cable to the device.
2.
Connect the other end of the Cat 5 cable from the device into an RJ-45 network port located
on the switch front panel.
Apply AC Power
The smart switch does not have an On/Off switch. Power is controlled by the power cord
connection.
connection.