Netgear PL500 PL500P-199PES Manual Do Utilizador

Safety Information

To ensure your own personal safety and to help protect your system from potential damage, 
follow these safety guidelines.

AC input: 100–240V, 0.25A (max.)

Operating temperature: 0–40 degrees C.

Actual data throughput will vary. Network conditions and environmental factors, including 

volume of network traffic, building materials and construction, and network overhead, 
lower actual data throughput rate.

Do not service any product except as explained in your system documentation.

Opening or removing covers that are marked with the triangular symbol with a lightning 
bolt can expose you to electrical shock. Only a trained service technician should service 
components inside these compartments.

Use the product only with approved equipment.

Allow the product to cool before removing covers or touching internal components.

To help avoid damaging your system, be sure that the voltage selection switch (if 
provided) on the power supply is set to match the power available at your location:

110 volts (V), 60 hertz (Hz) in most of North and South America and some Far 
Eastern countries such as South Korea and Taiwan

100V, 50 Hz in eastern Japan and 100V, 60 Hz in western Japan

230V, 50 Hz in most of Europe, the Middle East, and the Far East

The peripheral power cables are equipped with three-prong plugs to help ensure proper 
grounding. Do not use adapter plugs or remove the grounding prong from a cable.

Observe extension cable and power strip ratings. Make sure that the total ampere rating 
of all products plugged into the extension cable or power strip does not exceed 80 
percent of the ampere ratings limit for the extension cable or power strip.

To help protect your system from sudden, transient increases and decreases in electrical 
power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS).

For more safety instructions, see